Your carrot is upside down.

It's standing at attention!

It's just happy to see you.

Out of interest how did the label adhesive stand up to the heat of laminating?

Where did you find the 1/2" hole punch? I have been looking everywhere, and cant seem to find one.

I laminated mine as well, and they stick just fine.

Those look fantastic. Nice graphics.

Yeah, me too!

I have had my 1/2" punch for a while now. I got it at Michael's, in the scrapbooking section.

Jim

How did you heat the laminating sheets and did you completely envelope the counter or just the top section with the sticker?

Looking to do my set, but I want to do it right...I always screw it up the first time (sometimes 2nd and 3rd time...)

Okay, I will try there. I tried Hobby Lobby and Pat Catan's and Wal-Mart. I will try Michaels. Thanks.

Here's what I did-

Printed out on full page Avery label paper.
Took printout and put a blank sheet of paper behind it.
Ran this through my laminating machine using 3 mil plastic.
Cut out so I could peel off blank sheet.
Now I have the label paper with laminating plastic just on the front over sticker labels.
Cut into strips.
Pre-peeled label backing most of the way, then unpeeled it back.
Punched out each one with 1/2" circle punch.
Stuck on and rubbed them down real well with clean paper towel.


I originally tried Michaels but all they had were 5/8" punches. I first ordered from a company that so far has not send me my punch after 14 days and won't answer emails or answer their phone. So I instead ordered one from eBay. If you check the thread on this subject you can find links to the one on eBay.

I actually ran two sets of the sheet, for double sided stickers, then I ran them BACK TO BACK through my laminator, then split them on the sides. whammo, two one sided laminated sheets of stickers, for the cost of only one piece of laminate. no waste that way.